Technical Specifications Communication Interface: RS485 / Ethernet optional Power Supply: Powered by rack backplane Operating Temperature: 0℃ ~ +60℃ Mounting: 3500 rack slot mounting Housing: Metal rack card casing
Functional Features Protocol conversion between 3500 rack internal bus and standard industrial protocol. Transmit vibration, position, temperature, speed and alarm data to external control system. Support data read function for DCS and SCADA system. Built-in communication fault diagnosis. Hot swappable design. LED indicators for communication and module running status.
Application Scenarios Data communication gateway between 3500 machinery protection rack and DCS system. Data transmission for power plant turbine and compressor monitoring system. Petrochemical plant critical machinery monitoring data upload to control system. Industrial rotating machinery protection system connection with PLC and SCADA. Remote monitoring data transmission for key rotating equipment.
Performance Parameters Data refresh rate: Configurable cycle for data upload Communication stability: Anti-interference industrial communication Fault diagnosis: Detect link break and communication abnormality
Structural Characteristics Standard rack card metal shielding housing. Internal protocol conversion processor and communication circuit. Backplane connector for power and data exchange with rack backplane. Front panel communication terminals or network port and LED indicators. Front panel locking mechanism.
Working Principle The module reads real-time measurement and alarm data from rack interface module via rack backplane. It converts proprietary rack protocol into standard industrial communication protocol, then sends data to external DCS or SCADA system. It also monitors communication link status and reports communication failure.
Installation Requirements Insert module into designated slot of 3500 rack and lock front panel. Ensure backplane connector fully engages rack backplane. Connect communication cable to front panel interface according to protocol type. Set station address, baud rate or IP address in configuration software. Check communication status indicators after power on.
There are no reviews yet.