Technical Specifications Back‑plane internal system bus interface. Serial physical communication channel. Auxiliary power 24 V DC. Operating temperature 0 ℃ to +60 ℃, storage temperature ‑40 ℃ to +85 ℃, non‑condensing relative humidity 5%‑95%. Serial channel surge suppression protection.
Functional Features Completes protocol conversion and data transmission between system bus and serial peripheral equipment. Receives serial data from external devices and forwards to main controller. Transmits controller commands to external serial instruments. Front‑panel LED indicators display serial communication link status and module fault alarm. Built‑in hardware self‑diagnosis detects serial channel and bus link abnormality.
Application Scenarios Spare serial communication interface module for ABB control rack. Applied in industrial sites needing to connect serial‑protocol third‑party instruments.
Performance Parameters Stable serial data receiving‑sending performance. Reliable protocol conversion processing capacity. Accurate communication link status identification.
Material Composition Flame‑retardant plastic module housing. Multilayer glass‑fiber epoxy printed circuit board. Serial protocol processing and level conversion assemblies. Back‑plane plug‑in connector and serial signal terminals.
Structural Characteristics Standard rack plug‑in module. Front side equipped with serial signal terminals and status LED indicators. Rear side fitted with back‑plane bus connector. Weight approximately 0.31 kg.
Working Principle After power‑on initialization, INSEM01 establishes connection with back‑plane system bus. Serial data from external instruments enters module, completes level conversion and data parsing, then transmits to main controller. Controller commands are encapsulated into serial frame and sent to external peripheral devices.
Installation Requirements Connect external serial device wiring to front‑end terminals. Ensure back‑plane connector is fully engaged. Restore power supply, set serial communication parameters and verify bidirectional data interaction.
Usage Notes Set baud rate, data bit, parity bit consistent with external serial devices. Hot‑plug under powered state is prohibited. Verify serial data reading‑writing after parameter configuration.
There are no reviews yet.