Technical Specifications Back‑plane controller bus interface, multi‑channel RS‑232 / RS‑485 serial ports. Auxiliary power 24 V DC, typical power consumption 3.3 W. Operating temperature 0 ℃ to +60 ℃, storage temperature ‑40 ℃ to +85 ℃, non‑condensing relative humidity 5%‑95%. Serial channel signal isolation.
Functional Features Interacts with main controller through back‑plane system bus. Executes serial data packaging and parsing. Collects status and measurement data from external serial devices. Transmits controller commands to connected field equipment. Front‑panel LED indicates communication link and module fault status. Built‑in hardware self‑diagnosis detects serial port abnormality and internal circuit faults.
Application Scenarios Serial communication spare part for ABB Advant DCS control rack. Applied in process‑industry automation cabinet maintenance requiring serial‑device interconnection.
Performance Parameters Stable serial‑port data transmission performance. Reliable protocol data processing capability. Accurate communication fault identification.
Material Composition Flame‑retardant plastic module housing. Multilayer glass‑fiber epoxy printed circuit board. Serial protocol processing chip and signal isolation assemblies. Back‑plane plug‑in connector and serial signal terminals.
Structural Characteristics Standard rack plug‑in module. Front side fitted with serial communication terminals and status LED indicators. Rear side equipped with back‑plane bus connector. Weight approximately 0.31 kg.
Working Principle After power‑on initialization, module establishes serial communication with external devices. Received field data is processed and transmitted to controller via back‑plane bus. Controller commands are encapsulated into serial frames and sent outwards. Diagnosis circuit monitors serial link and module hardware operating state continuously.
Installation Requirements Insert DSCS150 into designated rack slot and lock fixing latch. Connect shielded serial communication cables to front‑end terminals. Ensure back‑plane connector is fully engaged. Restore power supply, configure serial communication parameters and verify bidirectional data exchange.
Usage Notes Set baud rate, parity and data bit consistent with external equipment. Use shielded cable for serial signal wiring.
There are no reviews yet.