Technical Specifications Back‑plane controller bus interface, fieldbus physical communication port. Auxiliary power 24 V DC, typical power consumption 4.3 W. Operating temperature 0 ℃ to +60 ℃, storage temperature ‑40 ℃ to +85 ℃, non‑condensing relative humidity 5%‑95%. Built‑in signal isolation circuit for fieldbus channel.
Functional Features Interacts with Advant controller through back‑plane bus. Executes fieldbus protocol processing and data packaging. Uploads process values, device status and fault alarm information. Receives remote configuration parameters and control commands from fieldbus master station. Front‑panel LED displays communication link status and module fault condition. Built‑in hardware self‑diagnosis detects bus interruption and internal circuit faults.
Application Scenarios Fieldbus communication spare part for ABB Advant DCS system. Applied in petrochemical, power and chemical plant automation cabinet maintenance.
Performance Parameters Stable real‑time bidirectional data transmission. Accurate protocol conversion performance. Reliable communication fault identification capability.
Material Composition Flame‑retardant plastic module housing. Multilayer glass‑fiber epoxy printed circuit board. Protocol processing chip and galvanic isolation assemblies. Back‑plane plug‑in connector and fieldbus connection port.
Structural Characteristics Standard rack plug‑in module. Front side equipped with fieldbus port and status LED indicators. Rear side fitted with back‑plane bus connector. Weight approximately 0.41 kilogram.
Working Principle Module completes hardware initialization after power‑on. IIncoming remote commands are parsed and delivered to controller for execution. Diagnosis circuit continuously monitors communication link and back‑plane bus operating status.
Installation Requirements Disconnect rack 24 V DC auxiliary power before replacement. Insert CI570 3BSE001440R1 into corresponding rack slot and lock fixing latch. Connect qualified fieldbus cable to front‑end port. Confirm back‑plane connector is fully engaged. Restore power supply, set station address and bus parameters, verify bidirectional data exchange.
Usage Notes Configure communication parameters strictly consistent with project design. Use industrial‑grade shielded fieldbus cables. Hot‑plug operation under powered condition is prohibited. Verify data reading and command response after module replacement.
There are no reviews yet.